Toggles Midpoint entity snap; snaps to the middle of lines, arcs, and other open entities, and edges of 3D solids.
Accessing the Command
command bar: midpoint
transparent: mid
toolbar: Entity Snaps | 
: midpoint
Displays no prompt in the command bar.
When midpoint entity snap is on, the cursor snaps to the midpoints of entities.
This entity snap works with 3D solid models.
Command Options
|
Option |
Description |
|
Midpoint |
Entering the command toggles Midpoint entity snap. It snaps to the midpoint of entities. This command can be entered transparently during commands, but must be entered without the apostrophe prefix ( ' ). |
Related Commands
OSnap - toggles entity snap modes in the Settings dialog box.
-OSnap - toggles entity snap modes in the command bar.
Aperture - sizes the aperture cursor for entity snaps.
2dIntersection - toggles apparent intersection snap mode.
3dIntersection - toggles intersection snap mode.
Apparent - toggles apparent intersection snap mode.
Center - toggles center snap mode.
Endpoint - toggles endpoint snap mode.
Extension - toggles extension snap mode.
From - allows to enter relative coordinates with respect to a reference point.
GCenter - toggles Geometric Center (GCenter) entity snap.
Insertion - toggles insertion snap mode.
Intersection - toggles intersection snap mode.
Mtp - allows to specify a point as the midpoint between two points.
Nearest - toggles nearest snap mode.
Node - toggles node (point) snap mode.
None - turns off all entity snap modes.
Parallel - toggles parallel snap mode.
Perpendicular - toggles perpendicular snap mode.
Quadrant - toggles quadrant snap mode.
Tangent - toggles tangent snap mode.
Zmidpoint - toggles the 3D midpoint snap. Snaps to the midpoint of a face edge.
| © Menhirs NV. All rights reserved. |