Toggles extension entity snap.
Accessing the Command
command bar: extension
transparent: extension
toolbar: Entity Snaps | 
: extension
No prompts in the command bar.
If extension entity snap is off, entering the command turns it on. And vice versa.
When extension entity snap is on, the cursor snaps to the intersection of one or two extended entities.
Command Options
|
Option |
Description |
|
Extension |
Entering this command toggles extension entity snap. This command can be entered transparently during commands, but must be entered without the apostrophe prefix ( ' ). |
Related Commands
OSnap - toggles entity snap modes in the Settings dialog box.
-OSnap - toggles entity snap modes in the command bar.
Aperture - sizes the aperture cursor for entity snaps.
2dIntersection - toggles apparent intersection snap mode.
3dIntersection - toggles intersection snap mode.
Apparent - toggles apparent intersection snap mode.
Center - toggles center snap mode.
Endpoint - toggles endpoint snap mode.
From - allows to enter relative coordinates with respect to a reference point.
Insertion - toggles insertion snap mode.
Intersection - toggles intersection snap mode.
Midpoint - toggles midpoint snap mode.
Mtp - allows to specify a point as the midpoint between two points.
Nearest - toggles nearest snap mode.
Node - toggles node (point) snap mode.
None - turns off all entity snap modes.
Parallel - toggles parallel snap mode.
Perpendicular - toggles perpendicular snap mode.
Quadrant - toggles quadrant snap mode.
Quick - toggles quick snap mode.
Tangent - toggles tangent snap mode.
| © Menhirs NV. All rights reserved. |