SmFlangeSplit

Platinum Platinum Platinum

Splits a flange along a line drawn on its face.

Accessing the Command

command bar: smflangesplit

menu bar: Sheet Metal | Split Flange

toolbar: Sheet Metal |

Quad: Sheet Metal |

: smflangesplit

Prompts you in the command bar:

Select a flange face: (Select the face of flange.)

Select a line to split the flange / draw a <New line>: (Select a line on the flange.)

Command Options

Option

Description

New line

Allows to draw a line on the selected flange.

Prompts you:

Start point of the line: Specify the start point of the line.

End point of the line: Specify the end point of the line.

Procedures

To split a flange

Related Commands

SmDelete - removes a bend or a junction by restoring a hard edge between two flanges; removes a flange with all the bends adjacent to it. The adjacent flanges are extended up to a junction configuration with the flange being deleted.

SmFlangeConnect - closes gaps between two arbitrarily oriented flanges.

SmFlangeEdge - creates one or more flanges to a sheet metal part by pulling one or more edges of an existing flange.

SmReliefCreate - makes proper corner and bend reliefs. Corner reliefs are built on corners which have three or more adjacent flanges. Bend reliefs are built on the start and end of a flange edge .