SmReliefCreate

Platinum Platinum Platinum

Makes proper corner and bend reliefs. Corner reliefs are built on corners which have three or more adjacent flanges. Bend reliefs are built on the start and end of a flange edge .

Accessing the Command

command bar:  smreliefcreate

menu bar:  Sheet Metal | Create Relief

toolbar:  Sheet Metal |

: smreliefcreate

Prompts you in the command bar:

Select a hard edge or bend face, flange face, 3D solid / <Entire model>: (Select an item.)

Select another hard edge or bend face for the corner relief / <Run with the current selection>: (Select another item or right click to execute the command on the current selection.)

Enter relief size by bend radius ratio <1.0>: (Type a value.)

Command Options

Procedures

Creating missing reliefs

Related Commands

SmBendCreate - converts hard edges (sharp edges between flange faces) into bends.

SmConvert - automatically recognizes flanges and bends in a 3D solid.

SmDelete - removes a bend or a junction by restoring a hard edge between two flanges; removes a flange with all the bends adjacent to it. The adjacent flanges are extended up to a junction configuration with the flange being deleted.

SmDissolve - removes sheet metal data from the selected faces.

SmFlangeEdge - creates one or more flanges to a sheet metal part by pulling one or more edges of an existing flange.

SmFlangeSplit - splits a flange along a line drawn on its face.

SmJunctionCreate - converts hard edges (sharp edges between flange faces) and bends into junctions.